Over the past two weekends Ive done a lot of work on my Laser. Alfonso came down last weekend and we worked 12+ per day on Friday Saturday and Sunday. Most of my time was spent cleaning up my deck and laying glass. In order to fix the mast step I had to cut a hole in the deck and lay some glass and epoxy around its base. Before I can spray new gel coat on the deck I have to patch that hole and make the deck smooth, then cover the deck with glass. The first photo below is showing the glass lip I attached to the inside of the hole, to hold the piece I cut out. Next was to actually place and level the piece of foam and glass that was cut out of the deck and lay some glass on the seam to seal it in. In the second photo below you can see where the bondo is on the bow section. In this photo I have already laid up two layers of glass over the bondo. earlier in the week I had been putting two layers of glass over the whole deck and cockpit which really strengthened the deck and there is now zero flexibility anywhere on the deck.

Once the glass on the deck was complete it was time to start spraying the hull once again. we put two coats of red gelcoat on the hull a week ago and now it was time for about 5 more. We actually ended up running out of red gel coat before the process was complete so I have to purchase another two gallons. The waterline stripe from its previous gel coat job was showing through even 7 thin layers of gel coat as you can see in the last photo.  I still have a lot of work to do to get this thing ready to sail but the process is nearing completion.  I still need to do some sanding in the cockpit to prepare it for gel coat and then comes the deck gel coat along with non-skid.  After that its just a matter of getting the thing rigged and spraying the foils (centerboard, rudder)